Twinix · line digital twin
Commission inspection before a camera is mounted
Twinix builds an Omniverse twin of the line and station so you can place cameras and lights, run Synvex defects past them, and see what each setup would catch before touching the line.
Specification
- Inputs
- Part CAD, station layout, camera and lens catalogue
- Simulation
- NVIDIA Omniverse with RTX rendering; Replicator scenarios from Synvex
- Outputs
- Coverage report; Veridex camera config and ROIs
- Runs on
- RTX workstation; large sweeps on DGX
What Twinix does
- 01
Line and station twin
Built in Omniverse from CAD and your line layout.
Core - 02
Virtual cameras and lights
Try lenses, angles, distances and lighting without a ladder.
Core - 03
Defect visibility checks
Run Synvex scenarios past each setup and see which defects are visible.
Core - 04
Inspection plan to Veridex
Camera settings and regions of interest go straight into the station config.
Core - 05
What-if for new SKUs
Check a new part against the current station before it reaches the line.
Core - 06
Inspection-cell planning
Robot paths for inspection cells in Isaac Sim (planned).
Planned
What Twinix produces
AX-204 station, 2 cameras vs 3 cameras
- Faces checked
- 6
- Defect scenarios
- 1,200 from Synvex
- Option A
- 2 cameras, ring light
- Option B
- 3 cameras, dome light
- Export
- Plan for Veridex
Inside Twinix
Model
Import CAD and the station layout.
Place
Add cameras and lights.
Simulate
Run defect scenarios past each setup.
Export
Send the chosen plan to Veridex.
Specification
Items marked planned are in design with pilot partners.
| Item | Detail |
|---|---|
| Inputs | Part CAD, station layout, camera and lens catalogue |
| Simulation | NVIDIA Omniverse with RTX rendering; Replicator scenarios from Synvex |
| Outputs | Coverage report; Veridex camera config and ROIs |
| Runs on | RTX workstation; large sweeps on DGX |
| Robotics | Isaac Sim inspection-cell planning (planned) |
| Collaboration | Shared twins in Omniverse Cloud (planned) |
Twinix in the Viseena loop
- P01 · GenerateSynvex
Renders labeled defect images from CAD, materials and a defect taxonomy.
- P02 · TrainCoreon
Fine-tunes a shared defect model into a per-SKU adapter, closing the sim-to-real gap.
- P03 · InspectVeridex
Runs the model on edge hardware at the station, at line speed, on every part.
- P04 · ExplainPilora
Turns flagged frames into defect reports, triage and probable root cause.
- P05 · CommissionTwinix
Simulates cameras and lighting in a line twin before anything is mounted.
Uncertain and confirmed real frames from Veridex flow back to Synvex and Coreon. Pilora triggers retraining when it sees drift, and Twinix sends new scenarios to Synvex before a changeover.
About Twinix
Do we need a full factory twin?
No. Twinix starts with one station: the part, the conveyor section and the camera mounts.
How close is the simulation to the real station?
Close enough to compare options, which is its job. We validate the chosen plan on the real station before go-live.
Who uses Twinix?
Automation engineers and integrators designing or retooling stations.
Try Twinix on one SKU
Pilots start with one part, one defect list and accuracy measured on real frames.